| Uploader: | Fezilkree |
| Date Added: | 6 March 2014 |
| File Size: | 65.65 Mb |
| Operating Systems: | Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X |
| Downloads: | 58751 |
| Price: | Free* [*Free Regsitration Required] |
PTC Programmer | Melexis
Afterwards the software verifies if the upload was done correctly. I advise to check the connection of the output pin. So if you have a pull-up resistor at the output of the in your final application, then I recommend that you also tpc-04 this load during the calibration. Press "Do not connect" in case you get a warning. The firmware loader is needed in order to upload new or other firmware into the PTC programmer.
Answer Melexis programmable hall sensors can only be programmed with the PTC no other option. Play the 2nd Item of the Playlist.
In all other cases I do not know any reason why you can not reprogram the device. In case of trouble, please recontact us on the Forum and we will address it quicker than this time. The is considered as a slave node. Typically the error message will be;: Stop loading and playing. The oscillation or unstability you have seen are directly linked to the noise or jitter which affects the angular reading.
Is there any method that i can use? You need to request a registration for the software distribution system.
Especially the Offset is obviously wrong. PTC Answer The function CheckSetup bQuiet As Booleanwill search for a PTC and also includes checking of communication channel validity, hardware revisions and specific parameters, software revisions as well as setting device specific parameters.
The programmer is designed to be easily adapted to a standard PC and to an application module to allow calibration of programmable sensor ICs within the operating environment. In your case it sound like the firmware is corrupted and does not fit with the requirements.
PTC-04 - Programmer for Melexis PTC devices
If the magnetic field is too strong or too weak you will receive an error code in case you work in SPI mode, and a diagnostic output level in case you selected the analog output mode. Please suggest soon as i have to make one Prototype using this IC. Cookies are small files we put in your browser to mainly track usage or remember your settings of our website.
The PTC programmer contains its own programmable power supply and measurement circuitry. I use a safety-critical sensor with dual MLX They are marked as BAD X1. Once the file is opened, the firmware is loaded in to the PTC programmer. If it matches then the problem is solved. Is it possible to program the device without the PTC?
Melexis Products
Question Refer to my datasheet of ,see the below: I am using the PTC to program the This can be done for example with the following instruction: Select the firmware needed for your MLX product. It is not possible to program them in one step.
To postpone the calibration check of the PTC04, one can otc-04 the Next calibration date to a later date. Answer The message "calibration date has expired"is just a warning. In those positions, you calibrate the transfer characteristic according to your output requirements offset, slope, If your application is degrees and if you do not need a calibration, you can also order the MLX already preprogrammed in SPI mode.
Comments
Post a Comment